Dimensional drawing
Installed equipment
Aggregates and mining
Belt feeders
Steady material feed at the start of the process. Ten DAF models from 1 to 6.6 m.
Features
- Belt widths of 700, 1,000, 1,200 and 1,500 mm.
- Outputs from 150 t/h to 1,200 t/h.
- Monoblock drive with manual speed variator.
- Discharge chute sized for the required product.
Benefits
- Precise feed control to the next machine.
- Compact size to fit into any plant.
- Minimum investment.
Added value
- Very low maintenance cost.
- Rubber-lagged drive drum with diamond pattern.
- Very robust construction.
Models and dimensions
| Model | A | B |
|---|---|---|
| DAF1 | 1000 | 700 |
| DAF2 | 1200 | 1000 |
| DAF3 | 1500 | 1200 |
| DAF4 | 6600 | 1200 |
| DAF5 | 3500 | 700 |
| DAF6 | 2500 | 1200 |
| DAF7 | 3500 | 1000 |
| DAF8 | 1200 | 700 |
| DAF9 | 3500 | 1200 |
| DAF10 | 2500 | 1000 |
Dimensions in mm as per drawing: A = length, B = width.
How much does each feeder produce?
The output of a feeder depends on the size and type of material fed to it and on how the feed rate is set. That is why we do not give a fixed figure: tell us about your material and we will size the model and output for your case.
2026 catalogue
Belt feeders catalogue
11-page PDF with photos, features, drawings and dimensions.
Related equipment
Complete your plant
Cubi-Roc centrifugal mill
Horizontal-shaft mill for producing sand with a stable grading curve. Up to 150 t/h.
Vibrating screens
Aggregate screening in two, three or four decks, dry or with spray bars. Thirteen models, with screening areas from 2.5 to 14 m².
Sand washer
Industrial sand washing with maximum fines recovery. From 50 to 200 m³/h, four LAF models.